INTERNATIONAL VC OFFSHORE ANTIFOULING EU 2L Black
Description
INTERNATIONAL VC OFFSHORE EU 2L
VC® OFFSHORE EU
Hard Antifouling
Suitable for salt and freshwater
Hard, smooth finish can be burnished to a smooth profile
For racing, sailing and power boats
Suitable for high speed craft
NOT suitable for use over aluminium/alloy substrates or zinc sprayed surfaces.Practical Coverage (m²/Lt): 10.5
Practical Coverage (m²/Lt): 10.5
No. of coats: 2 - 3
Substrates: GRP, Lead, Steel
Application: Roller
Thinner: VC® General Thinner (for clean up)
Rated "Excellent" on high fouling areas.
Specifications
Extras/Additional Info:
APPLICATION AND USE
Preparation VC OFFSHORE Wash down with fresh water.
OTHER ANTIFOULINGS Check for sound condition. Remove loose material. Rinse with fresh water and allow to dry.
BARE GRP Use VC General Thinner to clean and fully degrease the surface. Lightly sand with 240 grade paper. Rinse
with fresh water and allow to dry. Use VC Tar2 to prime and protect against osmosis.
STEEL Prime with VC Tar2 to prevent corrosion.
LEAD Prime with VC Tar2.
WOOD Prime with Primocon.
Method Apply 2 coats per season on the hull. 3 coats are required on the leading and trailing edges, waterline, rudder and keel.
This is important for best performance.
Hints Mixing Stir well before use. Pour the powder (stored under the plastic hat) into the can. Stir or shake thoroughly.
Cleaner YTA600 VC General Thinner. VC General Thinner can be used to remove splashes of VC Offshore from the
topsides.
Airless Spray Pressure: 176-210 bar. Tip Size: 1880-2180.
Conventional Spray Pressure: 2-3 bar. Tip size: 1.5-1.8 mm.
Other For Airmix spray application: Pressure: 2 bar. Tip Size: 20-113. True colour will develop after immersion. Take
care to apply all the paint calculated even if it means applying an extra coat
